Home > News > Content

Mechanical Hydraulic Paver Part Action

AKW GROUP | Updated: Oct 11, 2017

The paver is a hydraulic system failure, and if it fails, it is not a trivial matter, Mechanical Hydraulic Paver and the paver hydraulic system failure is often the result of a multifaceted factor, so it must be clear before analyzing the fault Hydraulic system principle, characteristics, Mechanical Hydraulic Paver and then based on the phenomenon of failure to judge.

There are some tips on finding the cause of the fault on the site. The most common method is to reverse the components, remove the load, etc., if the reverse component failure also reversed, it is proved that the component is a problem; if removed Load, failure disappeared, the problem is also understood. In short, there is a purpose, there is a direction to gradually narrow the scope of the fault to determine the fault area, location or a hydraulic component is necessary, avoid chaos, chaos. To avoid the blindness of the analysis, Mechanical Hydraulic Paver because the hydraulic flow within the pipeline, the hydraulic parts of the internal parts of the action, such as damage to the seal, is intangible, invisible. Statistics show that more than 70% of the hydraulic system failure directly or indirectly from the maintenance of improper or hydraulic oil pollution. Therefore, Mechanical Hydraulic Paver it is important to maintain the cleanliness and good maintenance of hydraulic fluids.

(1) Check if the tank level is too low. Experience shows that the oil temperature is often due to oil tank caused by lack of oil, so the lack of oil should be added in time.

(2) hydraulic oil filter and circuit is blocked.

(3) whether the radiator is normal. Mechanical Hydraulic Paver Radiators such as adhesion of a lot of dust, can lead to poor heat, so that the oil temperature. As the paver work environment more dust, so the radiator should be cleaned up in time.

(4) whether the quality of hydraulic oil qualified. If the oil quality is not acceptable, Mechanical Hydraulic Paver it will cause the system oil temperature is too high.

Paver products use a single, construction enterprises and production enterprises a higher degree of concentration, supply and demand by the road project investment, project start, the national policy-oriented greater impact. Mechanical Hydraulic Paver According to the China Construction Machinery Industry Association Road and Compaction Machinery Branch statistics, the cumulative capacity of the paver on the market has exceeded 28,000 units, Mechanical Hydraulic Paver but according to the paver construction hours and useful life, part of the paver is already scrapped or is Scrapped state, the current market can be used normally in the paver in about 20,000 units.